PointMax 4-Channel IO-Link Master Module

Summary Of Changes

Additional Resources

Download Firmware, AOP, EDS, and Other Files

Terminology

Construct a PointMax I/O System

Secure Access to the System

PointMax I/O in a Logix 5000 Control System

Controller and Software Compatibility

Module Firmware Updates

Connections

Ownership

Requested Packet Interval

Connection Optimization

Module Inhibiting

Electronic Keying

Protected Operations

Unicast or Multicast Connection

CIP Sync Time

Fault and Status Reporting

Software Configurable Input Filters

Input Timestamping

Configure Channel Output State When Module is in Program Mode or Inhibited

Configure Channel Output State in Communication Fault Mode

Short Circuit Detection

No Load Diagnostics

Highly Integrated IO-Link

Cyclic Mode

Change of State Mode

Input Events

IO-Link Device Identity

IO-Link Bus

IODD-based AOP for IO-Link Devices

Fallback Mode

IO-Link Device Connection

IO-Link Device Inhibiting

IO-Link Device Electronic Keying

Automatic Device Configuration

Data Storage

IO-Link Device Parameters Classification

Device Configuration

Device Correlation Check

Get/Set IO-Link Device Parameters

Configure IO-Link Process Data Output State When IO-Link Device is in Program Mode or Inhibited

Configure IO-Link Process Data Output State in Fault Mode

IO-Link Device Information and Diagnostics

Fault and Status Reporting

IO-Link Device Configuration Change Notification

Execute IO-Link Commands Through Explicit Messaging

Protection Mode for IO-Link Devices

IO-Link Events

Register IO-Link Device IODD

Import/Export IODD Files

Use Generic IO-Link Device Profile

Update Device Firmware

Add a New Module to a Studio 5000 Logix Designer Application Project

I/O Tag Name Conventions

Access I/O Tags

Troubleshoot Your IO-Link Master Module

Register IO-Link Device IODD

Import/Export IODD Files

Add IO-Link Devices to Your Project

Add a Generic IO-Link Device

I/O Tag Name Conventions

Access I/O Tags

Replace IO-Link Devices

Adjust Device Configuration After Replacement

Clone/Duplicate a Machine

Use Explicit Messages to Read and Write IO-Link Device Parameters

Configure IO-Link Device through Configuration Tags

Reset IO-Link Device to Factory Default

Troubleshoot Your IO-Link Device

Specifications

Module Configuration

Use the Status Indicators for Troubleshooting

Module Tag Definitions

Diagnostic Assembly

IO-Link Device Configuration

IO-Link Device Tag Definitions