Startup/Faults configuration page

Use the

Startup/Faults

configuration page to do the following actions:

Configure the startup settings for the

Micro800

controller in the

FactoryTalk Design Workbench

project.

Open the controller diagnostics view to review memory information for the current project and the project stored in memory.

Specify the controller behavior when a hard fault occurs.

TIP: Before changing the

Mode Behavior

and

Fault Override

settings, disconnect the controller.

Startup/Faults configuration page settings.
Setting	Description
Diagnose	Opens the Controller Diagnostics view. Diagnose is available when the controller is online.
Mode Behavior	Specifies the startup behavior of the Micro800 controller on power-up. Options are: Retain last mode before power-down Remote run mode Retain last mode before power-down is the default setting.
Fault Override	Specifies the fault behavior during controller power-up. Options are: Do not clear faults Clear faults Do not clear faults is the default setting.
Hard Fault	Specifies the controller behavior when a hard fault occurs. Options are: Stop the controller Automatically restart the controller Stop the controller is the default setting.
Memory Module (L50E and L70E controllers)/Memory Card (L20E controllers)	Displays the message and a link to the memory card or memory module configuration page. The link is available for: L20E controllers that support the memory card. L50E and L70E controllers with the 2080-SDMEMRTC-SC or 2080-MEMBAK-RTC2 plug-in module.

Provide Feedback

Have questions or feedback about this documentation? Please submit your feedback here.