Open the DNP3 Slave configuration page using DNP3 slave protocol via a serial port

Use the following steps to open the
DNP3 Slave
 configuration page when using DNP3 slave protocol via a serial port.
To open the DNP3 Slave configuration page when using DNP3 slave protocol via a serial port
  1. In
    Project Organizer
    , double-click the controller node to open the controller workspace.
  2. From the
    Controller
     tree, select
    Serial port
    .
  3. On the
    Serial Port
     configuration page, from the
    Driver
     list, select
    DNP3 slave
    .
  4. From the
    Controller
    tree, select
    DNP3 Slave
    .
  5. If you are using the 2080-SERIALSOL plug-in module for DNP3 communication
Provide Feedback
Have questions or feedback about this documentation? Please submit your feedback here.
Normal