PointX view parameters (output)

Select to enable PWM. Clear the checkbox to disable PWM. These values are contained in the Output tags and must be edited in the Output tags or through Program Control. The option is displayed here (while online) to help in configuring PWM.

Type the minimum time required for the output to turn On. This value must be defined in seconds. By default, the minimum on time is 0.0 seconds.

Select the checkbox to increase the pulse cycle duration to maintain the On time to Cycle time ratio while taking into account the minimum On time. Extending the cycle time is typically useful only when the On time is dynamic.

Clear the checkbox if you do not want to increase the duration of the pulse cycle. In this case, the output does not turn On if the On time is less than the minimum On time. By default, the checkbox is cleared.

Select the checkbox to minimize the load on the power system by staggering output transitions.

Clear the checkbox to disable staggering. When staggering is disabled for an output point, the output always turns On at the beginning of a pulse cycle.

Define the On Time in seconds or as a percent of the Cycle Time.

Select the checkbox to allow only a fixed number of pulse cycles to occur.

Clear the checkbox to allow the pulse cycles to continue until the output turns off.

Type the number of pulses to occur if

Enable Cycle Limit

is selected (1 … 127).

Select the checkbox to always execute the number of cycles specified in the Cycle Limit field regardless of the output state.

Clear the checkbox to limit the number of cycles by the output state. By default, the

Execute All Cycles

checkbox is cleared.

Select to copy the current output point configuration to one or more of the remaining output points.