Points view parameters (output devices)

Displays the point number to which this configuration applies.

Determines the behavior of each output when the controller transitions to Program mode. While in Program mode, outputs from the controller are ignored and the output behaves according to these:

Determines what happens to the output of each point after a communication fault occurs and the device enters Communications Fault mode.

Determines the length of time the Fault Value value is held prior to the Final Fault State.

Tip: This parameter is not supported for the 5069-OW4I and -OX4I devices.

Determines whether the device transitions to On or Off after the Fault Mode Output State Duration elapses. The default final state is Off. If you choose Forever for Duration, you cannot choose a final state. The device retains its current Fault mode state.

Tip: This parameter is not supported for the 5069-OW4I and -OX4I devices.

Determines the output action if communication fails in Program Mode.

Determines whether No Load detection is enabled. No Load detects whether a signal wire has been disconnected from one of its terminals or the RTB has been removed.

Opens

Ptxx Diagnostics

for diagnostic information.