Change the EtherNet/IP Mode in the Logix Designer Application

This example shows the
EtherNet/IP™
 mode change from Dual-IP mode to Linear/DLR mode. The same tasks apply to change from Linear/DLR mode to Dual-IP mode
IMPORTANT: With
ControlLogix®
 5590 controllers, the Ethernet ports on the controller itself are labeled 1 and 2. In programming and communication software, the ports are described as A1 and A2.
Make sure that you are aware of the effects of changing the
EtherNet/IP™
 mode. See Change the EtherNet/IP Mode.
  1. Confirm that the project is offline.
  2. On the General tab of the Controller Properties dialog box, click Change IP Mode.
    This image shows where to click on controller properties to change the IP mode in Logix Designer.
  3. From the New mode dropdown, choose the new mode and click OK.
    This image shows where to change the EtherNet/IP mode in Logix Designer.
  4. Click OK on the Controller Properties dialog box.
  5. Save the project.
  6. Download the updated project to the controller.
  7. When the following warning appears, read it carefully.
  8. Click Yes to continue.
    This image shows where to click Yes to change the EtherNet/IP mode in Logix Designer.
Provide Feedback
Have questions or feedback about this documentation? Please submit your feedback here.
Normal