Peer Commands
TIP:
Before you configure peer commands, it is recommended to first add and configure all
EtherNet/IP™
In-cabinet system devices in the controller project. The devices must exist
in the system before you can define peer commands.Peer-to-peer communication in an
EtherNet/IP™
In-cabinet system allows devices to exchange data directly with each other and perform actions based on their own configuration, without relying on the connected controller.Once a device is configured to request peer data, the device transmits peer messages to the target devices directly, whether or not they are connected to the controller.
IMPORTANT:
Configuring
CIP Security™
and using peer-to-peer communications is not recommended.Provide Feedback