Device Configuration
This section describes how to add and monitor HART devices that are connected to your
analog HART input or output module in a Studio 5000 Logix Designer application project.
- Some HART device profiles are pre-loaded in the Studio 5000 Logix Designer application and are recognized when you connect them to HART enabled channels.
- Some HART devices need Electronic Device Description (EDD) information updates before you can use them.
- Some HART devices are not recognized and need generic profiles to connect to the channels.
TIP:
In an output module, the power to the field device is provided by the channel. If the
channel is not energized, the HART device is not powered on.
Provide Feedback