Command a step or
Equipment Phase
 using the Sequence Detail Control

Command an
Equipment Phase
 through a step using the Sequence Detail Control.
TIP:
Select
Active Step Change
 L5K_SILC_initializetags_icon_V25 to make a step active.
Before you begin
  • Open a display that contains the Sequence Detail Control.
  • The
    Equipment Sequence
     must be in
    Manual
    mode.
  • The step to be commanded must be active. This implies the step is attached to the
    Equipment Phase
     to be commanded.
To command a step using the
Equipment Sequence
 Monitor
    1. Select
      Take Ownership
      L5K_SILC_unselected_takeownership to take ownership of the
      Equipment Sequence
      .
    2. Select the active step to see the
      Equipment Sequence
       step command toolbar.
    3. Select a command to command the equipment phase associated with the step.
    4. (optional) Once you have completed commanding phases, select
      Exit Manual
      L5K_SILC_ManualModeIcon_v26 to go back to
      Automatic
      mode.
    5. When finished, select
      Release Ownership
      L5K_SILC_takeownership_sequence_V25.
Provide Feedback
Have questions or feedback about this documentation? Please submit your feedback here.
Normal