Controller 4-character Status Display
With the
Studio 5000 Logix Designer®
application, you can disable certain categories of messages on the four-character status display.You use a CIP Generic MSG to execute each option.
IMPORTANT:
You cannot disable these system messages, and they always display:
- Power-up messages, such as TEST, PASS, CHRG
- Catalog number message
- Firmware revision message
- Major / Critical failure messages
The 4-character status display returns to the default setting after one of these actions occurs on the controller:
- Stage 1 reset
- Stage 2 reset
- New project is downloaded - In this case, the settings in the new project take effect.
- Program is cleared from the controller - these examples can clear the program from a controller:
- Major nonrecoverable fault occurs.
- Firmware update occurs.
You must reconfigure the settings to disable the 4-character status display after it returns to its default settings.
Provide Feedback