XX – Output, Logic Controlled view parameters (5034-UB8F)

Specifies whether Ptxx.Data participates in the OR logic calculation.

Select which points affect the state of this output point. The state of the output point is determined by the logical OR of the selected points in the OR table, combined with logical AND of the selected points in the AND table.

You can select multiple points, each configured in one of the following modes, to participate in the logic calculation:

Digital Output
Digital Output, Logic Controlled
Digital Output, Triggered Pulse
Digital Output, Scheduled
Digital Input
Digital Input, Timestamp
Digital Input, FIFO

Specifies whether Ptxx.Data participates in the AND logic calculation.

Select which points affect the state of this output point. The state of the output point is determined by the logical OR of the selected points in the OR table, combined with logical AND of the selected points in the AND table.

You can select multiple points, each configured in one of the following modes, to participate in the logic calculation:

Digital Output
Digital Output, Logic Controlled
Digital Output, Triggered Pulse
Digital Output, Scheduled
Digital Input
Digital Input, Timestamp
Digital Input, FIFO

Determines the behavior of each output when the controller transitions to Program Mode or Inhibit mode. While in Program Mode or Inhibit mode, outputs from the controller are ignored and the output behaves as follows:

Off – Output is 0 or Off.
On – Output is 1 or On.
Hold – Output maintains the last state.
Local Control – Output continues to operate as configured for this point.

Determines what happens to the output of each point after a communication fault occurs and the module enters Communication Fault Mode.

Off – Output is 0 or Off.
On – Output is 1 or On.
Hold – Output maintains the last state.
Local Control – Output continues to operate as configured for this point.

Determines the length of time the Communication Fault Mode is held before the Final Fault State.

Determines whether the module transitions to On or Off after the Communication Fault Mode Output State Duration elapses. The default final state is Off.

If you choose Forever for Duration, you cannot choose a final state. The module retains its current Communication Fault Mode state.

Determines the output action if communication fails in Program Mode.

Leave Outputs in Program Mode State – Indicates leaving outputs in Program Mode state.
Change Outputs to Communication Fault Mode State – Indicates changing outputs to Communication Fault Mode state.

Opens the Diagnostics dialog, which contains diagnostic information.