1734sc-OE2CIH Module Configuration

Use this tab to configure the Spectrum Controls 1734sc-OE2CIH HART analog output module.

On this tab, you can enter a pass through hold time.

Tip
: The module’s configuration information is stored in the controller and the controller configures the module.

Note
: The 1734sc-OE2CIH Owner’s Guide, which is available online by following the hyperlink on the Vendor tab, provides additional configuration information for some of the parameters discussed in this help file.

HART Pass Through Hold Time

Enter a Hold Time value for the final reply of the pass-through message.

After the module obtains the requested information from the HART device, it will start the Hold Timeout timer (duration defined by the HoldTime tag). The reply message will be kept in memory during the Hold Time period. After the timeout occurs, or after the message is retrieved by the pass-through response query command, the storage buffer will be discarded and another pass through message will be serviced without being rejected. Hold Time is in the range of 0 to 255 seconds.

Click this button to accept your edits on any tab and close the dialog.

Cancel

Click this button to cancel your edits on any tab and close the dialog.

Apply

Click this button to apply your edits on any tab and continue editing.

If:

you are online in Program, Remote Program or Remote Run mode and,

this controller is the owner controller and,

you have changed the module’s configuration in the software, when you click the Apply or the OK button, the information is automatically sent to the controller. The controller tries to send the information to the module (if the module’s connection is not inhibited). If you don’t click Apply, your changes are not sent to the controller.

Help

Click this button for help on this tab.