1734sc-OE2CIH Limits Configuration
Use this tab to configure the Spectrum Controls 1734sc-OE2CIH HART analog module clamping limits.
On this tab, you can:
- enable the latch rate alarm
- enter clamp limit values
Tip
: The module’s configuration information is stored in the controller and the controller configures the module.Note
: The 1734sc-OE2CIH Owner’s Guide, which is available online by following the hyperlink on the Vendor tab, provides additional configuration information for some of the parameters discussed in this help file.Clamp Limit Values
High Limit
Set the level of output to a channel during program/fault mode.
Low Limit
Set the level of output to a channel during program/fault mode.
Latch Rate Alarm checkbox
When you enable this alarm, a Rate Alarm indication will remain set even when the alarm condition goes away. This latch allows you to maintain the alarm even after the condition ceases. The alarm will only unlatch with an explicit message acknowledging the alarm (unlatch service).
OK
Click this button to accept your edits on any tab and close the dialog.
Cancel
Click this button to cancel your edits on any tab and close the dialog.
Apply
Click this button to apply your edits on any tab and continue editing.
If:
- you are online in Program, Remote Program or Remote Run mode and,
- this controller is the owner controller and,
- you have changed the module’s configuration in the software, when you click the Apply or the OK button, the information is automatically sent to the controller. The controller tries to send the information to the module (if the module’s connection is not inhibited). If you don’t click Apply, your changes are not sent to the controller.
Help
Click this button for help on this tab.
Provide Feedback