Configure Dual-IP Mode in the Logix Designer Application

You can configure the controller for Dual-IP mode with the
Studio 5000 Logix Designer®
 application. The
EtherNet/IP™
 mode is Dual-IP by default and is displayed on the General tab in the Controller Properties dialog box.
IMPORTANT: With
ControlLogix®
 5590 controllers, the Ethernet ports on the controller itself are labeled 1 and 2. In programming and communication software, the ports are described as A1 and A2.
This image shows where the EtherNet/IP mode is shown on the controller properties dialog box in Logix Designer.
You set the IP address and subnet mask on the Internet Protocol tab.
TIP:
When you set the IP address and subnet mask, we recommend that you use a USB connection from the workstation to the controller.
Use this procedure to set the IP address on port 1 and port 2.
  1. Confirm that the project is online.
  2. Confirm that the controller is in one of the following modes.
    • Program
    • Remote Program
    • Remote Run
    You cannot change the IP address or subnet mask if the controller is in Run mode.
  3. Click the Internet Protocol tab.
  4. From the Port dropdown menu, choose an Ethernet port.
  5. Click Manually configure IP settings.
  6. Assign the IP address and network mask values.
  7. Click Apply.
Provide Feedback
Have questions or feedback about this documentation? Please submit your feedback here.
Normal