1486-CON Connectors
The bus uses 1486-CON connectors to attach system components to the 1486-CBL flat media cable.
- 1486-CON connectors cannot be added to or removed from an active system.
- Any unpopulated connector must be capped with a 1486-CON-D1 connector cover.
- Only one device can be removed at a time.
The following table shows available 1486-CON connectors for your
EtherNet/IP™
In-cabinet system.Cat No. | Description | For Use with | Connector Supplied with Cat. No. |
|---|---|---|---|
1486-CON-D1  | Connector cover with test access points | 1486-CON-P1 connectors installed on the cable, which are unused or unplugged | — |
 1486-CON-P1 | Connector, straight through | 100-E, 104-E, 800F communication interfaces | 100-E-INT-D, 100E-INT-X, 104-E-INT-D, 104-E-INT-X, 800F-INT, 800F-INT-L |
1486-CON-P2L  | Connector, covers left end of cable | 1834-AENTR gateway and 1834-SUP-PWR supplemental power tap | 1834-AENTR, 1834-SUP-PWR |
1486-CON-P2R  | Connector, covers right end of cable | 1834-AENTR gateway and 1834-SUP-PWR supplemental power tap | 1834-SUP-PWR |
1486-CON-S1  | Connector, joins two cables | Extending or repairing cable | — |
1486-CON-T1  | Connector, media termination | End of bus/cable | 1834-AENTR |
Provide Feedback